What should you pay attention to when using the silicone tact switch?

1. When soldering the soft-touch switch terminal, if a load is applied to the terminal, it may loosen due to different conditions, and the deformation and electrical characteristics may deteriorate. Please pay attention when using it.

2. When using a through-hole printed circuit board or a board other than the recommended one, the influence of thermal stress will change. Please confirm the welding conditions beforehand.

3. When performing two weldings, please perform the first welding part after returning to normal temperature. Continuous heating may deform the outer peripheral portion, loosening of the terminal, falling off, and deterioration of electrical characteristics.

4. Regarding the condition setting of the welding, it is necessary to confirm the actual mass production conditions.

5. The product is designed and manufactured on the premise of DC resistance load. When using other loads [inductive load, capacitive load], please check separately.

6. For printed circuit board mounting holes and modes, please refer to the recommended dimensions listed in the product drawing.

7. Switch should be used to directly operate the switch according to the structure of the switch. Please do not use it for mechanical testing. Silicone tact switch

8. When the soft touch switch is operated, if the specified load is applied, the switch may be damaged. Be careful not to apply more than the specified force on the switch.

9. Please avoid using the operation part from the side.

10. For the flat shaft type, press the center of the switch as far as possible. For the hinge structure, the shaft will move when pressed,

so please pay special attention.

11. When the switch is installed, contact the professional if it passes through the heat storage hardening furnace due to the hardening of the adhesive of other parts.

12. If corrosive gas is generated in the material around the machine using the switch, it may cause contact failure, so please confirm it beforehand.

13. The carbon contact point has a characteristic that the contact resistance changes due to the pressing load. For use in voltage divider circuits, etc., please use them after sufficient confirmation.

14. For models other than the sealed type, please pay attention to the intrusion of foreign matter.

Due to its small size, long life, and light touch, it is widely used in many fields such as household appliances. With the continuous improvement of people's living standards, the upgrading of these household appliances is getting faster and faster, and the number of them needs to be larger and larger. This is also the biggest potential direction for us to be optimistic about its development prospects. Silicone button switch supply